Artifactory comes with a built-in embedded Derby database that can be reliably used to store data (metadata) for production-level repositories up to hundreds of gigabytes in size.
However, Artifactory supports pluggable database implementations allowing you to change the default to use other popular databases.
Artifactory currently supports the following databases:
For each of the supported databases you can find the corresponding properties file inside
Choosing the Right Database
As the default database, Derby provides good performance since it runs in the same process as Artifactory, however, under intensive usage or high load, performance may be degraded since Artifactory and the database compete for shared JVM resources such as caches and memory. Therefore, for Artifactory servers that need to support heavy load, you may consider using an external database such as MySQL or PostgreSQL which are very common choices in many Artifactory installations.
Any of the other supported databases is also a fair choice and may be the practical choice to make if your organization is already using one of them.
When using an external database, you need a reliable, stable and low-latency network connection to ensure proper functioning of your system.
When using a fullDB configuration, we strongly recommend a high-bandwidth to accommodate the transfer of large BLOBs over the network.
Modes of Operation
Artifactory supports two modes of operation:
- Metadata in the database and binaries stored on the file system (This is the default and recommended configuration).
- Metadata and binaries stored as BLOBs in the database
Artifactory uniquely stores artifacts using checksum-based storage. For details, please refer to Checksum-Based Storage.
Before You Start
Changing the database does not automatically transfer your data to the new database. Please follow the steps below to backup your data so that you can restore it after the change.
Backup Your Current Installation
When changing the database for an existing installation you must first perform a Full System Export using the "Exclude Content" option. Once your new database is set up and configured, you will import this data to re-populate your Artifactory metadata content.
Make sure to backup your current Artifactory system before updating to a new database. You will need your Artifactory instance to be disconnected from the network to avoid usage during this procedure.
Setup the New Database
To setup your new database you need to perform the following steps:
- Create a database instance
- Create an Artifactory user for the database
- Install the appropriate JDBC driver
- Copy the relevant database configuration file
- Configure the corresponding
- Start Artifactory
- Import the metadata using Full System Import
These steps are fully detailed in the specific documentation page for each of the supported databases listed in the Overview.
Once you have setup your database, you can configure it to support your expected load with the following two parameters:
|The maximum number of pooled database connections (default: 100).|
|The maximum number of pooled idle database connections (default: 10).|