The basic pre-requisites for Enterprise+ is an Artifactory service and Mission Control. Get started by downloading and installing Artifactory and Mission Control, as described below.
This Artifactory service will be used as your Authentication provider, serving as the central location for managing your users, groups and permissions.
|Please reference your Enterprise+ welcome email for your Enterprise+ license buckets.|
Install your Artifactory instance according to the.
Install Mission Control according to the.
Mission Control is your Enterprise+ onboarding starting point. This wizard includes the following two mandatory Enterprise+ configurations:
Load license bucket
The Mission Control onboarding wizard will prompt you to enter your Enterprise+ license bucket.
Start Mission Control and complete the Onboarding Wizard. For additional details, refer to the.
For each Artifactory service you want to add to Enterprise+, you'll need to install it, add it as a service to Mission Control, and configure it.
If you plan to add Distribution to your Enterprise+ product suite, you'll also need to perform a few additional steps in order for Distribution to work with your Artifactory service:
Establish a circle of trust between your source Artifactory and Artifactory Edge Nodes. For additional details, refer to the JFrog Access User Guide under.
This will optimize replication when distributing with JFrog Distribution. For additional information, refer to the.
As part of the distribution flow, Artifactory needs to interact with JFrog Distribution which relies on HTTP/1.1 protocol functionalities, such as chunked transfer encoding. For additional information, refer to the.
For each Xray and Distribution service you want to add to Enterprise+, you'll need to install it, configure it, and add it as a service to Mission Control.